How to properly maintain the wearing parts of Raymond Mill

Besoin d'aide pour utiliser les fonctionnalités du site ou du forum?
Règles du forum
Si aucun topic n'est lié à votre problème, merci de créer un nouveau topic par problème rencontré.

How to properly maintain the wearing parts of Raymond Mill

Messagepar crushermachine » Jeu 01 Août 2019, 05:34

Due to the long working time of Raymond mill, it brings people benefits and continuous loss. Therefore, when using the equipment daily, we should pay attention to the maintenance of the equipment. In addition to some maintenance, some parts that cannot be touched are needed. These have played a key role in the normal operation of the Raymond mill. Then, how to properly maintain the wearing parts of Raymond Mill.
1. The blade of Raymond Mill mainly shovels the material between the grinding roller and the grinding ring, so that the material is fully crushed. When the blade continuously shovels the material, the materials of different quality and hardness are used for a long time. The contact friction is easy to be worn. In severe cases, the blade will not be able to shovel the material, which will affect the working efficiency of the Raymond mill.
Second, the grinding roller and the grinding ring are the wearing parts in the whole equipment. In the production process of the Raymond mill, the material passes directly between the grinding roller and the grinding ring, so that it is squeezed and rotated by the two to achieve fine crushing. Effect. Because the grinding roller and the grinding ring are constantly subjected to the friction of the material, and are subjected to frictional forces between each other. When the grinding roller and the grinding ring are severely worn, or when the wear is uneven, it will have a certain influence on the fine powder production, and thus the unevenness of the fineness of the finished product may occur.
Third, Raymond mill's blade, grinding roller and grinding ring play a very important role in the production, and in the entire crushing process, play an irreplaceable role, so this is the easiest Raymond mill The worn parts. Remind users that during the production process, it is recommended to check the degree of wear of the blade, grinding ring and grinding roller frequently, and maintain the wearing parts reasonably to extend the service life.
The above is about the maintenance of the wearing parts of Raymond Mill, I hope to help everyone.
crushermachine
 
Message(s) : 172
Inscrit le : Sam 20 Oct 2018, 04:06
MP: Contacter

Retour vers Aide à l'utilisation de MKtrial.fr

Qui est en ligne ?

Utilisateur(s) parcourant ce forum : Aucun utilisateur inscrit et 1 invité

cron